• 首页 | 期刊简介 | 编委会 | 投稿须知 | 出版道德规范 | 下载专区 | English
崔新忠*,范亚夫,陈捷.685均质钢静动态断裂韧性实验研究[J].实验力学,2012,27(3):326~334
685均质钢静动态断裂韧性实验研究
Experimental Research of Quasi-static and Dynamic Fracture Toughness of 685 Homogeneous Steel
投稿时间:2011-07-18  修订日期:2011-12-02
DOI:
中文关键词:  685钢  霍普金森杆  动态断裂韧性  加载率
英文关键词:685 steel  Hopkinson bar  dynamic fracture toughness  loading rate
基金项目:
作者单位
崔新忠* 1.装甲与反装甲材料技术国防科技重点实验室, 山东烟台 264003
2. 中国兵器工业集团第五二研究所, 山东烟台 264003 
范亚夫 1.装甲与反装甲材料技术国防科技重点实验室, 山东烟台 264003
2. 中国兵器工业集团第五二研究所, 山东烟台 264003 
陈捷 中国兵器工业集团第五二研究所, 山东烟台 264003 
摘要点击次数: 459
全文下载次数: 446
中文摘要:
      为了解685均质钢的裂纹在静态加载和动态加载下的裂纹起裂和扩展情况,分别在静态试验机和基于Hopkinson杆技术改进的动态加载装置上采用三点弯曲试样对685均质钢的静、动态断裂韧性进行了研究。685均质钢中存在的少量孪晶马氏体组织对其断裂韧性造成了不利影响,可以适当降低碳含量来改善685均质钢的断裂韧性性能。当加载率KI≤1.8778×106MPa√m/s时,685均质钢的动态断裂韧性值都随加载率的增加而下降。当加载率KI>1.8778×106MPa√m/s时由于裂纹尖端热软化效应的影响,使得该材料的动态断裂韧性值又上升。采用高速摄影技术记录了裂纹的起裂和扩展,测得了裂纹的扩展速率。发现用裂纹嘴张开位移(Crack Mouth Opening Displacement,CMOD)法计算得到的动态断裂韧性值与用电阻应变片计算的结果相一致。
英文摘要:
      In order to investigate the crack initiation and development of 685 homogeneous steel under quasi-static loading and dynamic loading, quasi-static fracture toughness and dynamic fracture toughness were tested respectively by using quasi-static loading testing machine and modified Hopkinson bar and adopting three-point bend specimen. Fractographs reveal that twinned martensite causes the fracture toughness decline of 685 homogeneous steel. Carbon is the element that strongly promotes the formation of twinned martensite. So carbon content should be reduced properly to improve the fracture toughness of 685 homogeneous steel. When the loading rate KI is under 1.8778×106MPa√m/s, the dynamic fracture toughness of 685 homogeneous steel decreases with the increase of the loading rate. However, when the loading rate KI is higher than 1.8778×106MPa√m/s, the dynamic fracture toughness of 685 homogeneous steel rises due to the effect of thermal softening near the crack tip. Crack initiation and development were recorded by high speed camera technique. Crack propagation velocity was measured. The calculated dynamic fracture toughness by using (Crack Mouth Opening Displacement) CMOD method is consistent with that calculated from the signal of resistance strain gauge.
查看全文  下载PDF阅读器
关闭

网站版权:《实验力学》编辑部
您是本站第 65667357 位访问者,今日一共访问260次,当前在线人数: 0
技术支持:本系统由北京勤云科技发展有限公司设计