• 首页 | 期刊简介 | 编委会 | 投稿须知 | 出版道德规范 | 下载专区 | English
郝南松*,杨文超,杨基明.低Re数下变弯度机翼的非定常气动特性实验研究[J].实验力学,2014,29(3):294~301
低Re数下变弯度机翼的非定常气动特性实验研究
Experimental Study of Unsteady Aerodynamic Characteristics of Variable Camber Wing at Low Reynolds Number
投稿时间:2013-05-16  修订日期:2013-11-13
DOI:10.7520/1001-4888-13-078
中文关键词:  可变弯度机翼  动态气动特性  粒子成像测速(PIV)  雷诺数
英文关键词:variable camber wing  dynamic aerodynamic characteristics  particle image velocimetry (PIV)  Reynolds number
基金项目:国家自然科学基金资助项目(90816026)
作者单位
郝南松* 1.中国科学技术大学, 安徽合肥 230027
2.中国空气动力研究与发展中心, 四川绵阳 621000 
杨文超 中国科学技术大学, 安徽合肥 230027 
杨基明 中国科学技术大学, 安徽合肥 230027 
摘要点击次数: 1419
全文下载次数: 668
中文摘要:
      利用变弯度机翼模型及相关的风洞实验平台,开展了以弯度变化速率影响为重点的机翼非定常特性研究。实验结果显示,在低Re数(~105)下,机翼弯度非定常变化得到的升阻力系数曲线与准定常条件下的结果存在显著差异。具体表现为:准定常状态下,曲线表现出明显的可逆性;而弯度非定常变化时,曲线在弯度递增区和递减区之间存在明显的迟滞效应,而且随着变形速率的增加,这种迟滞也越明显。流场显示结果表明,这种小St数下出现的流动迟滞是由于弯度变形导致的流动分离的分离点相对机翼运动迟滞所造成的。这说明弯度变化时,分离流场结构的响应时间尺度与弯度变化周期相当,也揭示了该条件下机翼弯度变化对流动的抑制作用主要是通过改变分离区的大小来实现的。
英文摘要:
      An experimental investigation on unsteady aerodynamic characteristics of variable camber wing was carried out by a low-speed wind tunnel, which focuses on the effect of camber change rate. Experimental results show that at low Re number (~105), the lift and drag coefficient curves exhibit significant difference comparing with that under quasi steady condition due to wing camber unsteady change. For quasi steady flow, curves present significant reversibility; but when camber changes unsteadly, curves present obvious hysteresis between camber increment and camber decrement zones, further more, when camber variation rate goes faster, hysteresis becomes more obvious. Flow visualization results show that for such small St number flow, the unexpected hysteresis is mainly due to the movement retardation of flow separation point resulted from camber change relative to wing movement. This indicates that when camber changes, the response time scale of separation flow structure considerably matches with camber change cycle. This also reveals that under such condition, flow inhibition from wing camber change is achieved mainly by changing separation zone size.
查看全文  下载PDF阅读器
关闭

网站版权:《实验力学》编辑部
您是本站第 65667713 位访问者,今日一共访问438次,当前在线人数: 0
技术支持:本系统由北京勤云科技发展有限公司设计