• 首页 | 期刊简介 | 编委会 | 投稿须知 | 出版道德规范 | 下载专区 | English
王志,何存富,刘秀成*,陈彬,宋亚虎,王博.应力和组分占比对马氏体-铁素体双相钢中磁巴克豪森噪声的影响[J].实验力学,2021,36(1):43~50
应力和组分占比对马氏体-铁素体双相钢中磁巴克豪森噪声的影响
Effect of applied stress and phase proportion on the magnetic Barkhausen noise in martensite-ferrite steel
投稿时间:2020-01-19  修订日期:2020-03-06
DOI:10.7520/1001-4888-20-016
中文关键词:  磁巴克豪森噪声  应力  组分占比  双相钢
英文关键词:magnetic Barkhausen noise  stress  phase proportion  dual-phase steel
基金项目:国家重点研发计划(2018YFF01012300)资助; 国家自然科学基金(11527801,11872081)资助
作者单位
王志 北京工业大学 机械工程与应用电子技术学院 北京 100124 
何存富 北京工业大学 机械工程与应用电子技术学院 北京 100124 
刘秀成* 北京工业大学 机械工程与应用电子技术学院 北京 100124 
陈彬 中信重工机械股份有限公司 计量检测中心 河南洛阳 471039 
宋亚虎 中信重工机械股份有限公司 计量检测中心 河南洛阳 471039 
王博 中信重工机械股份有限公司 计量检测中心 河南洛阳 471039 
摘要点击次数: 688
全文下载次数: 302
中文摘要:
      磁巴克豪森噪声(MBN)技术在马氏体-铁素体双相钢的微观结构及应力无损评价与表征中具有巨大潜力。为探究拉应力和铁素体占比对磁巴克豪森噪声的影响规律及权重,在0~200MPa范围内实验测得了具有不同铁素体占比的双相钢MBN信号。重点分析了MBN蝶形曲线双峰峰值(分别代表马氏体和铁素体)在应力和铁素体占比两因素耦合条件下的变化趋势。结果表明:受多种竞争机制影响,铁素体对应的MBN信号峰值随应力和铁素体占比增加未呈现明显变化规律;铁素体占比增加过程中,马氏体对应的MBN信号峰值呈先快速后缓慢的两阶段增长趋势,且第二阶段的增长速率在高应力区间更快。应力和铁素体占比增加均会导致马氏体MBN信号峰值升高,当铁素体占比小于12%时,组分占比的影响权重更高;当铁素体占比大于12%时,两因素的影响权重相当。
英文摘要:
      Magnetic Barkhausen noise (MBN) technique has great potential in non-destructive evaluation of microstructure and stress in martensite-ferrite steel. To investigate the influence and weight of applied tensile stress and ferrite proportion on MBN, experiments are performed in dual-phase steel with different ferrite proportion under tension in the range of 0~200MPa. The change trends of double peaks (representing martensite and ferrite respectively) of MBN butterfly curve under the coupling condition of stress and ferrite proportion are specially analyzed. The results show that the MBN peak corresponding to ferrite hardly changes obviously with the increase of stress and ferrite proportion due to the complex competition mechanism. The MBN peak corresponding to martensite increases rapidly at first and then increases slowly as the ferrite proportion increases. In addition, the growth rate of the second stage is faster in the high stress range. Stress and ferrite proportion will lead to the increase of MBN peak value. In general, the phase proportion is the dominant influence factor when the ferrite proportion is less than 12%, and the influence weight of stress and ferrite proportion is in the same order when the ferrite proportion exceeds 12%.
查看全文  下载PDF阅读器
关闭

版权所有:《实验力学》编辑部
您是本站第 65264078 位访问者,今日一共访问1422次,当前在线人数: 0
技术支持:本系统由北京勤云科技发展有限公司设计