• 首页 | 期刊简介 | 编委会 | 投稿须知 | 出版道德规范 | 下载专区 | English
赵腾飞,邢保英*,何晓聪,曾凯,冯震.热轧双相钢-铝合金黏接-自冲铆接头不同腐蚀环境下的耐久性研究[J].实验力学,2022,37(6):875~880
热轧双相钢-铝合金黏接-自冲铆接头不同腐蚀环境下的耐久性研究
Study on durability of bonding-self-piercing riveting joints in hot rolled dual phase steel-aluminum alloy under different corrosion environments
投稿时间:2021-07-13  修订日期:2021-09-26
DOI:10.7520/1001-4888-21-169
中文关键词:  自冲铆接  腐蚀环境  静力学分析  元素分析
英文关键词:self piercing riveting  corrosive environment  static analysis  elemental analysis
基金项目:国家自然科学基金资助项目(52065034);云南省应用基础研究计划青年项目(14051848)
作者单位
赵腾飞 昆明理工大学 机电工程学院 云南昆明 650500 
邢保英* 昆明理工大学 机电工程学院 云南昆明 650500 
何晓聪 昆明理工大学 机电工程学院 云南昆明 650500 
曾凯 昆明理工大学 机电工程学院 云南昆明 650500 
冯震 昆明理工大学 机电工程学院 云南昆明 650500 
摘要点击次数: 364
全文下载次数: 93
中文摘要:
      为探究热轧双相钢-铝合金黏接-自冲铆接头(黏-铆复合接头)在不同腐蚀环境下的耐久性,以0.6mol/L的NaCl溶液和0.02mol/L的NaHSO3<\sub>溶液作为腐蚀液,对热轧双相钢(DP590)-铝合金5052黏-铆复合接头进行干湿周浸交替腐蚀实验,通过腐蚀动力学和静力学测试,研究接头在不同腐蚀环境下的静力学性能和失效机理。发现盐性环境下试件损失量呈递增趋势,酸性环境下试件损失量先增大后减小。酸性环境下随腐蚀的进行,接头承受载荷的最大值逐渐减小,对接头的不利影响更为突出;盐性环境下接头承受载荷的最大值先增大后减小,但对胶层的破坏程度更严重。两种腐蚀环境对接头的失效形式无显著影响,均为铆钉从下板拉脱;盐性环境中接头搭接区域腐蚀更为严重,上板表面氧、氯元素含量明显增加。
英文摘要:
      In order to explore the durability of hot rolled dual phase steel-aluminum alloy bonding-self-piercing riveting joints (adhesive-riveted composite joint) in different corrosion environments, the adhesive-riveted composite joint in hot-rolled dual phase steel(DP590) and aluminum alloy 5052 was tested by cyclic wet dry immersion corrosion test with 0.6mol/L NaCl solution and 0.02mol/L NaHSO solution as corrosion solution. The static mechanical properties and failure mechanism of the joint in different corrosive environments were studied. It is found that in the salt environment, the loss amount of specimen increases. But in the acid environment, the amount of specimen loss first increases and then decreases. In the acid environment, the maximum load of the joint decreases with the corrosion, and the adverse effect on the joint is more prominent. In the salt environment, the maximum load of the joint first increases and then decreases, but the damage to the adhesive layer is more serious. Moreover, the two corrosion environments have no significant effect on the failure mode of the joint, and the rivet is pulled off from the lower plate. In the salt environment, the corrosion in the lap joint area is more serious, and the contents of O and Cl on the surface of the upper plate increase significantly.
查看全文  下载PDF阅读器
关闭

版权所有:《实验力学》编辑部
您是本站第 65263494 位访问者,今日一共访问1122次,当前在线人数: 0
技术支持:本系统由北京勤云科技发展有限公司设计